Free shipping on orders over $50. Terms & Conditions Apply.
A US LEADING Magnet Supplier
100% SECURE Online Ordering

Hornby Train (12.7 x 9.3 x 13/25") N42 Neodymium Magnets w/ 6/61" hole

High performance neodymium magnets, specifically designed to replace the 0.5 inch magnets in model locomotive motors including Hornby Dublo, Wrenn Locomotives and Tri-ang X03/X04 motors.

Higher Quantities? Contact us today for volume pricing.

Loading...
Item in Stock   |   Same day dispatch when ordered before 11:30am EST (Mon - Fri)
  • $10.82
Product Code: F12913
Shape: Rectangular
Magnetic Face: 12.7mm x 9.3mm
Thickness: 13.2mm
Grade: N42
Plating: Ni-Cu-Ni ( Nickel )
Material: NdFeB
Max Temp (degrees C): 80
Fixing: Araldite/Loctite
  • 1/2 '' x 26/71'' x 13/25'' with a 6/61'' hole
  • +/-0.004" tolerance
  • Each magnet's north and south pole are on the faces with the holes, so the hole runs parallel to the direction of magnetism
  • Suitable for Hornby Dublo, Wrenn Locomotives and Tri-ang X03/X04 motors
  • Excellent resistance to demagnetisation
  • Coated with three layers of nickel, copper and nickel to reduce corrosion and provide a smooth finish

These magnets have been specifically designed to replace the magnets in the motors of model locomotives. As these magnets are made from the strongest magnetic material, they will provide much more torque than the alnico magnets historically used. What’s more, they will never lose their magnetism. Bring your locomotive back to life simply by replacing your old magnet with these high-performance neodymium magnets.

Showing our 1 review for Hornby Train (12.7 x 9.3 x 13/25") N42 Neodymium Magnets w/ 6/61" hole. Write a review ›
Review Summary - 5 out of 5 based on 1 rating.
December 27, 2020 | Stephen Moore
Replacing Tri-Ang/Hornby XO3/4 motor magnets

A direct replacement for the magnet in the XO3/4 motor. Resulted in an immediate improvement not only of torque (pulling power), but slow running ability and less stalling on my locomotive stock of 1960's origin. Note however if the magnet is installed "upside down" the motor will run in the opposite direction to before. If this happens remove and reinsert other way up to correct. Take care though as these magnets are very strong. Highly recommended.

Magnet Expert Ltd
Top